FS: Burton Hyperspa...
 

FS: Burton Hyperspace 156  

  RSS

nmb
 nmb
(@notmikebuckley)
Member Forum Superstar!
Joined: 3 years ago
Posts: 1153
29/04/2019 4:57 pm  

Yo dudes, rumors at work are flying again and a good chance my department gets downsized or I am replaced during the merger.  Just dropped some coin for summer semester and would rather use this money towards rent than dip into savings.  Life is screwy right now.  Here was my FLEAbay description;

"As a part of The Source’s 25th anniversary, the Hyperspace arrives as an exclusive collaboration between The Source and Burton. Designed from the ground up to be the ultimate hit-run board, the Hyperspace is intended to be sized down slightly for maximum maneuverability without compromising on all terrain stability. Every geometric detail was obsessed over, including a wider waist width for solid landings, a tapered directional shape for turn-on-a-dime quickness, and directional camber to blast through crud while offering maximum ollie power and snap. Built at Craig’s, Burton’s exclusive prototype facility in Vermont, The Hyperspace is limited to only 25 units and is destined to go down as one of The Source's most celebrated boards ever. "

 
"Go absolutely anywhere with this deep-floating, hard-carving, side-hit smashing hybrid design, made specifically for the folks at The Source"
 
Serial Number: 197100012
Waist Width: 260mm
Sidecut Radius: 7.2m
Effective Edge:  1155mm
Bend: Directional Camber
Taper: 10mm
Core: Fsc Certified Super Fly II 700G Core w/ Dualzone EGD & Squeezebox
Fiberglass: Triax with Carbon I-Beam
Base: Sintered WFO
Extras: Channel, Super-Sap Epoxy, ReRez, Pro-Tip, Infinite Ride
 
1 of 25 built for The Source shop.  Built at Craig's in Vermont.
**this board is used and not pristine**
-There is binding rash, slight channel chew, and some of the clear topsheet underfoot is spotting.  There is scuffing on the topsheet.
-The base is in good shape with no major imperfections but would benefit from a hot wax. I can put some Hertel Hot Sauce on before shipping if requested. 
-There are three small spots that hav been p-texed near the tail (I would revisit the one near the edge) and one spot right above the Family Tree.  
-The edges are in good shape but would benefit from a tune, never detuned, some slight rust.
-As far as I know, this board will be released as the One-Hitter in the 19/20 Family Tree lineup.
Sold as is.
 
If you want more pictures, shoot me a text at five eight six 344 7914.
 
$400 F&F +shipping @mikehoncho you can have first dibs since you reached out to me first awhile back
 
s l16009
7
s l16005
s l16002
1
s l1600

skier


Quote
nmb
 nmb
(@notmikebuckley)
Member Forum Superstar!
Joined: 3 years ago
Posts: 1153
29/04/2019 4:58 pm  

s l16003

If I could keep this I would!

skier


ReplyQuote
MikeHoncho
(@mikehoncho)
Member Forum Superstar!
Joined: 3 years ago
Posts: 255
29/04/2019 9:30 pm  

I’ll pass.  Thanks though...


ReplyQuote
Share: